The air cleaner element must be kept clean to provide good engine power and g1as mileage. If you use your motorcycle under normal low-stress conditions, you should service the air cleaner at the intervals specified. If you ride in dusty, wet, or muddy conditions, you will need to inspect the air cleaner element much more frequently.
Use the following procedure to remove the element and inspect it.
Warning
Never run the engine without the air cleaner element properly installed. |
Caution Clean or replace the air cleaner element frequently if the motorcycle is used in dusty, wet or muddy conditions. The air cleaner element will clog under these conditions, and this may cause engine damage, poor performance, and poor fuel economy. Clean the air cleaner case and element immediately if water gets in the air cleaner box. |
Air cleaner element removal
Air cleaner element
Inspect the air cleaner element condition. Replace the air cleaner element periodically.
Installation
Reinstall the air cleaner element in the reverse order of the removal.
Caution A torn air cleaner element will allow dirt to enter the engine and can damage the engine. Carefully examine the air cleaner element for tears during cleaning. Replace it with a new one if it is torn. |
Caution Failure to position the air cleaner element properly can allow dirt to bypass the air cleaner element. This will cause engine damage. Be sure to properly install the air cleaner element. |
Self-diagnostic procedures
Use of mode select switch
Note
do not disconnect the coupler from ecm,
battery cable from battery, ecm ground
wire from engine or main fuse before
confirming dtc (diagnostic trouble code)
stored in memory. Such disconnection
may erase memorized information in ec ...
Rear brake caliper parts inspection
Refer to “rear brake caliper disassembly and assembly” .
Brake caliper cylinder
Inspect the brake caliper cylinder wall for nicks,
scratches or other damage. If any damage is found,
replace the caliper with a new one.
Brake caliper piston
Inspect the brake caliper piston surface for any
s ...
Front turn signal light removal and installation
Removal
Remove the screw.
Disconnect the front turn signal coupler (1).
Remove the turn signal light assembly (2).
Installation
Install the front turn signal light in the reverse order of
removal. ...