Suzuki GSX-R 1000 Service Manual: Air cleaner box removal and installation
Removal
- Lift and support the fuel tank. Refer to “fuel tank removal and installation” in section 1g (page 1g- 9).
- Remove the air cleaner box cover. Refer to “air cleaner element removal and installation” .
- Remove the air cleaner mounting bolt.
- Remove the air cleaner box bolt.
- Disconnect the iat sensor coupler (1), pcv hose (2) and pair hose (3).
- Disconnect isc hose (4) and iap sensor (5).
- Remove the air cleaner box.
Installation
Install the air cleaner box in the reverse order of removal. Pay attention to the following point:
- route the hoses properly. Refer to “throttle body construction” .
- Tighten air cleaner box bolts in the ascending order.
Refer to “throttle body construction” .
Air cleaner element inspection and cleaning
Refer to “air cleaner element inspection” in section 0b .
Air cleaner element removal and installation
Removal
Lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Remove the air cleaner box cover (1).
Remove the air cleaner ...
Throttle cable removal and installation
Removal
Remove the air cleaner box. Refer to “air cleaner box removal and
installation” .
Remove the right handlebar switch box. Refer to “handlebar removal and
installation” in sect ...
Other materials:
Front brake light switch inspection
Inspect the front brake light switch in the following
procedures:
disconnect the front brake light switch coupler (1).
Inspect the front brake light switch for continuity with
the tester.
If any abnormality is found, replace the front brake light switch with a new
one. Re ...
DTC “c28” (p1655): secondary throttle
valve actuator (stva) malfunction
Detected condition and possible cause
Detected condition
Possible cause
The operation voltage does not reach the stva.
Ecm does not receive communication signal from the
stva. Stva can not operate properly or its motor locked
Stva malfunction.
...
License plate light bulb replacement
Caution
when you touch the bulb with your bare
hands, clean the bulb with a cloth moistened
with alcohol or soap water to prevent
premature bulb failure.
Remove the license plate light mounting nuts.
Remove the lens cover (1) by removing the screws.
Re ...