Removal
Installation
Install the ap sensor in the reverse order of removal.
To sensor inspection
Refer to “dtc “c23” (p1651-h/l): to sensor circuit malfunction” in section 1a .
Front brake pad replacement
Loosen the pad mounting pins (1).
Remove the brake caliper by removing the caliper
mounting bolts (2).
Remove the pad mounting pins (1), brake pads and
spring.
Caution
do not operate the brake lever while the pads
are removed.
Note
when ...
Sprocket mounting drum dust seal / bearing removal and installation
Removal
Remove the rear wheel assembly. Refer to “rear wheel assembly removal
and installation” in section 2d .
Remove the rear sprocket mounting drum assembly
(1). Refer to “rear sprocket / rear sprocket
mounting drum removal and installation” (page 3a-
3).
Remove the ...
Fuel injector inspection and cleaning
Inspect the fuel injector in the following procedures:
remove the fuel injector. Refer to “throttle body disassembly and
assembly” in section 1d .
Check the fuel injector for evidence of dirt and
contamination. If present, clean and check for
presence of dirt in the fuel lin ...