Refer to “engine bottom side disassembly” (page 1d- 49).
Refer to “engine bottom side assembly” .
Inspection
Inspect the bearing surfaces for any signs of fusion, pitting, burn or flaws. If any, replace them with a specified set of bearings.
Selection
Special tool (a): 09900–22301 (plastigage (0.025 – 0.076 Mm))
Caution never rotate the balancer shaft when a piece of plastigauge is installed. |
Tightening torque crankshaft journal bolt (m9): 18 n·m (1.8 Kgf-m, 13.0 Lbf-ft) then turn in 50° crankcase bolt (m8) (initial): 15 n·m (1.5 Kgf-m, 11.0 Lbf-ft) crankcase bolt (m8) (final): 26 n·m (2.6 Kgf-m, 19.0 Lbf-ft) crankcase bolt (m6): 12 n·m (1.2 Kgf-m, 8.5 Lbfft)
Balancer shaft journal oil clearance standard: 0.028 – 0.052 Mm (0.0011 – 0.0020 In) service limit: 0.080 Mm (0.0031 In)
Code number “a”, [a], [b] or [c] which is stamped on the rear of upper crankcase.
Bearing selection table
Crankcase I.D. Specification
Balancer shaft journal o.D. Specification 19.992 – 20.000 Mm (0.7871 – 0.7874 In)
Bearing thickness specification
Note the balancer shaft journal bearings on upper and lower crankcases are the same. |
Headlight beam adjustment
Adjust the headlight beam, both horizontally and
vertically.
Note
to adjust the headlight beam, adjust the
beam horizontally first, then vertically.
It is not necessary to remove the
combination meter to turn the adjusters.
Horiz ...
Oil pressure switch inspection
Inspect the oil pressure switch in the following
procedures:
Note
before inspecting the oil pressure switch, check if the engine oil level
is correct. Refer to “engine oil and filter replacement” in section 0b .
Remove the left side cowling. Refer to “exterior parts removal ...
Specifications
Specifications
Note
these specifications are subject to change without notice.
Dimensions and dry mass
Engine
Drive train
Chassis
Electrical
Capacities
...