Refer to “engine bottom side disassembly” (page 1d- 49).
Refer to “engine bottom side assembly” .
Removal
Remove the balancer shaft journal bearings (1).
Note
|
Caution when removing the bearings, be careful not to scratch the bearings. |
Installation
When installing the bearings to the crankcases, be sure to install the tab “a” first, and then press in the other opposite side of the bearing.
Note inspect and select the balancer shaft journal bearing if necessary. Refer to “balancer shaft journal bearing inspection and selection” . |
Front brake master cylinder parts inspection
Refer to “front brake master cylinder / brake lever disassembly and assembly”
.
Master cylinder
Inspect the master cylinder bore for any scratches or
other damage
Piston / rubber parts
Inspect the piston surface for any scratches or other
damage.
Inspect the primary cup, secondary cup ...
Tp sensor removal and installation
Refer to “throttle body disassembly and assembly” in section 1d .
Removal
Remove the throttle body. Refer to “throttle body
removal and installation” in section 1d (page 1d-
10).
Remove the tp sensor (1) with the special tool.
Special tool
: 09930–11950 (torx wrench (5 mm))
...
Pair system inspection
Pair hose
Lift and support the fuel tank with the prop stay.
Refer to “fuel tank removal and installation” in section 1g .
Remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Inspect the pair hoses for wear or damage. If it is worn or da ...