Initial charging filling electrolyte
Note when filling electrolyte, the battery must be removed from the vehicle and must be put on the level ground. |
Note
|
Note do not allow any of the electrolyte to spill. |
Note if no air bubbles come out from a filler port, tap the bottom of the electrolyte container two or three times. Never remove the container from the battery. |
Caution
|
Charging
For initial charging, use the charger specially designed for mf battery.
Caution
|
Battery recharging
Caution do not remove the caps on the battery top while recharging. |
Note when the motorcycle is not used for a long period, check the battery every 1 month to prevent the battery discharge. |
If the voltage reading is less than the 12 v (dc), recharge the battery with a battery charger.
Recharging time 1.2 A for 5 to 10 hours or 5 a for 1 hour
Caution be careful not to permit the charging current to exceed 5 a at any time. |
If the battery voltage is less than 12.5 V, recharge the battery again.
If the battery voltage is still less than 12.5 V after recharging, replace the battery with a new one.
|
Rear brake pedal adjustment
The rear brake pedal position
must be properly adjusted at all
times or the disk brake pads will
bear against the disk causing
damage to the pads and to the
disk surface. Adjust the brake
pedal posit~ on in the following
manner:
Loosen lock nut 1, and turn
the push rod 2 to locate t ...
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Front brake master cylinder components” “rear brake master
cylinder components” “rear brake pedal construction”
Special tool
...
Schematic and routing diagram
Fuel tank drain hose and breather hose routing diagram
Fuel tank water drain hose
Fuel tank breather hose no. 1
Fuel tank breather hose no. 2
Fuel tank breather hose no. 3
3-Way joint
Frame
White marking
Set the
hose end to the root of tank nippl ...