Troubleshooting
Step |
Action |
Yes |
No |
1 | Check accessories which use excessive amounts of
electricity. Are accessories being installed? |
Remove accessories. | Go to step 2. |
2 | Check the battery for current leakage. Refer to “battery
current leakage inspection” . Is the battery for current leakage ok? |
Go to step 3. |
|
3 | Measure the regulated voltage between the battery
terminals. Refer to “regulated voltage inspection” (page 1j-
3). Is the regulated voltage ok? |
|
Go to step 4. |
4 | Measure the resistance of the generator coil. Refer to “generator
inspection” . Is the resistance of generator coil ok? |
Go to step 5. |
|
5 | Measure the generator no-load performance. Refer to “generator
inspection” . Is the generator no-load performance ok? |
Go to step 6. | Faulty generator |
6 | Inspect the regulator/rectifier. Refer to “regulator / rectifier
inspection” . Is the regulator/rectifier ok? |
Go to step 7. | Faulty regulator/rectifier |
7 | Inspect wirings. Is the wirings ok? |
Faulty battery. |
|
Rear combination light removal and installation
Removal
Remove the frame cover assembly. Refer to “exterior parts removal and
installation” in section 9d .
Remove the clamps (1).
Disconnect the combination light coupler (2).
Remove the rear combination light assembly (3).
Remove the combination light brack ...
Exhaust control valve inspection
Inspect exhaust control valve
initially at 1 000 km (600 miles, 2 months) and every
12 000 km (7 500 miles, 24 months) thereafter
Inspect exhaust control valve as follows:
remove the left side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Check t ...
Front suspension adjustment
After installing the front fork, adjust the spring pre-load
and two kinds of damping force as follows:
Adjust the
left and right front forks to the
same setting.
Spring pre-load adjustment
Turn the spring pre-load adjuster (1) counterclockwise
fully. From that position (softe ...