Toyota RAV4 manuals

Suzuki GSX-R 1000 Owners Manual: Brake fluid

Suzuki GSX-R. Brake fluid


Check the brake fluid level in both front and rear brake fluid reservoirs. If the level in either reservoir is below the lower mark, inspect for brake pad wear and leaks.

Warning


Brake fluid is harmful or fatal if swallowed, and harmful if it comes in contact with skin or eyes.

If swallowed, do not induce vomiting. Immediately contact a poison control center or a physician. If brake fluid gets in eyes, flush eyes with water and seek medical attention. Wash thoroughly after handling.

Solution can be poisonous to animals. Keep out of the reach of children and animals.

 

Warning


Failure to keep the brake fluid reservoir full with proper brake fluid can be hazardous. The brakes may not work correctly without the proper amount and type of brake fluid. This could lead to an accident.

Inspect the brake fluid level before each use. Use only dot4 brake fluid from a sealed container. Never use or mix different types of brake fluid. If there is frequent loss of fluid, take your motorcycle to a suzuki dealer or qualified mechanic for inspection.

 

Caution

Spilled brake fluid can damage painted surfaces and plastic parts.

Avoid spilling any fluid when filling the reservoir. Wipe up spills immediately.

Brakes
This motorcycle has front and rear disk brakes. Warning Failure to inspect and properly maintain the brakes increases your chance of having an accident. Inspect the brake system ...

Brake pad
Front Rear Inspect the front and rear brake pads to see if they are worn down to the grooved wear limit line 1. If a pad is worn to the grooved wear limit line, it must be replaced with ...

Other materials:

Tires
Warning Failure to follow these warnings may result in an accident due to tire failure. The tires on your motorcycle form the crucial link between your motorcycle and the road. Follow these instructions:  check tire condition and pressure, and adjust pres ...

Wiring harness routing diagram
Wiring harness no. 2 Tapping clamp : insert the clamp from the front side. Place the turn signal and position light couplers in front of the clamp. Steel clamp : clamp the wiring harness at the blue taping point. Bend the steel clamps to the front side. ...

Front fork removal and installation
Note the right and left front forks are installed symmetrically and therefore the removal procedure for one side is the same as that for the other side. Removal Remove the front wheel. Refer to “front wheel assembly removal and installation” in section 2d . ...

© 2011-2024 Copyright www.suzukigsxr.org