Suzuki GSX-R 1000 Service Manual: Brake fluid replacement
Caution
handle brake fluid with care: the fluid reacts
chemically with paint, plastic, rubber
materials, etc. |
Front brake
- Place the motorcycle on a level surface and keep the
handlebars straight.
- Remove the brake fluid reservoir cap and
diaphragm.
- Suck up the old brake fluid as much as possible.
- Fill the reservoir with new brake fluid.
Bf: brake fluid (dot 4)
- Connect a clear hose to the air bleeder valve and
insert the other end of the hose into a receptacle.
- Loosen the air bleeder valve and pump the brake
lever until the old brake fluid flows out of the brake
system.
- Close the air bleeder valve and disconnect the clear
hose.
Tightening torque
air bleeder valve (front caliper): 7.5 N·m (0.75
Kgf-m, 5.5 Lbf-ft)
- Fill the reservoir with brake fluid to the upper mark of
the reservoir.
- Bleed air from the brake fluid circuit. Refer to “air bleeding from
brake fluid circuit” .
- Install the diaphragm and reservoir cap.
Rear brake
- Place the motorcycle on a level surface.
- Remove the right side frame cover. Refer to “exterior parts removal and
installation” in section 9d .
- Remove the rear brake fluid reservoir mounting bolt
(1).
- Remove the brake fluid reservoir cap and
diaphragm.
- Suck up the old brake fluid as much as possible.
- Fill the reservoir with new brake fluid.
Bf: brake fluid (dot 4)
- Connect a clear hose to the air bleeder valve and
insert the other end of the hose into a receptacle.
- Loosen the air bleeder valve and pump the brake
pedal until the old brake fluid flows out of the brake
system.
- Close the air bleeder valve and disconnect the clear
hose.
Tightening torque
air bleeder valve (rear caliper): 6 n·m (0.6 Kgfm,
4.5 Lbf-ft)
- Fill the reservoir with brake fluid to the upper line of
the reservoir.
- Bleed air from the brake fluid circuit. Refer to “air bleeding from
brake fluid circuit” .
- Install the diaphragm and reservoir cap.
- Install the removed parts.
Air trapped in the brake fluid circuit acts like a cushion to
absorb a large proportion of the pressure developed by
the master cylinder and thus interferes with the full
braking performance of the ...
Removal
Drain brake fluid. Refer to “brake fluid replacement” .
2) Remove the front brake hoses as shown in the front brake hose routing
diagram. Refer to “front brake hose routing diagram” ...
Other materials:
Conclusion
Traffic, road and weather conditions
vary. Other motorists'
actions are unpredictable. Your
motorcycle's condition can
change. These factors can best
be dealt with by giving every ride
your full attention.
Circumstances beyond your control
could lead to an accident. You
need to prepare fo ...
Rod guide case tightening torque
Tighten the rod guide case in the following procedures:
measure the effective length l of the torque wrench.
Calculate the reading torque on the torque wrench by
use of the formula shown below.
Special tool
(a): 09940–84710 (rod guide case
wrench)
T: reading torque on the torq ...
Front brake caliper removal and installation
Note
the right and left calipers are installed
symmetrically and therefore the removal
procedure for one side is the same as that for
the other side.
Removal
Drain brake fluid. Refer to “brake fluid replacement” in section 4a .
Remove the brake hose from the cali ...