Front
Rear
Inspect the front and rear brake pads to see if they are worn down to the grooved wear limit line 1. If a pad is worn to the grooved wear limit line, it must be replaced with a new one. After replacing either the front or rear brake pads, the brake lever or pedal must be pumped several times. This will extend the pads to their proper position.
Warning
Inspect brake pad wear before each use. Ask your suzuki dealer or qualified mechanic to replace brake pads if any pad is worn to the limit. |
Warning
Before riding, "pump" the brake repeatedly until brake pads are pressed against the brake disks and proper lever/ pedal stroke and firm feel are restored. |
Note
: do not squeeze/depress the brake lever/pedal when the pads are not in their positions. It is difficult to push the pistons back and brake fluid leakage may result.
Clamp
Clamp the wire harness at such positions as indicated in “wiring harness
routing diagram” in section 9a .
Bend the clamp properly so that the wire harness is
clamped securely.
In clamping the wire harness, use care not to allow it
to hang down.
Do not use wire or an ...
Throttle valve synchronization
Check and adjust the throttle valve synchronization
among four cylinders.
Start the engine and run it in idling condition
for
warming up.
Stop the warmed-up engine.
Lift and support the fuel tank. Refer to “fuel
tank
removal and installation” in section 1g (page ...
Engine bottom side disassembly
Note
the crankcase must be separated to service
the crankshaft and conrod.
Remove the engine assembly from the frame. Refer to “engine assembly
removal” .
Remove the engine top side (1). Refer to “engine top side disassembly”
.
Crankcase breather (pcv) cover
R ...