The first 800 km (500 miles) is the most important in the life of your motorcycle. Proper operation during this break-in period will help assure maximum life and performance from your new motorcycle.
The following guidelines explain proper break-in procedures.
Maximum engine speed recommendation
The table below shows the maximum engine speed recommendation during the break-in period.
Vary the engine speed
Vary the engine speed during the break-in period. This allows the parts to "load" (aiding the mating process) and then "unload" (allowing the parts to cool).
Although it is essential to place some stress on the engine components during break-in, you must be careful not to load the engine too much.
Breaking in the new tires
New tires need proper break-in to assure maximum performance, just as the engine does. Wear-in the tread surface by gradually increasing your cornering lean angles over the first 160 km (1 00 miles) before attempting maximum performance. Avoid hard acceleration, hard cornering, and hard braking for the first 160 km (1 00 miles).
Warning
Use extra care when riding on new tires. Perform proper break-in of the tires as described in this section and avoid hard acceleration, hard cornering, and hard braking for the first 160 km (100 miles). |
Allow the engine oil to circulate before riding
Allow enough idling time after warm or cold engine start up before revving the engine or placing the transmission in gear. This allows time for the lubricating oil to reach all critical engine components.
Observe your initial and most critical service
The initial service (break-in maintenance) is the most important service your motorcycle will receive. During break-in operation, all of the engine components will have mated together and seated. Maintenance required as part of the initial service includes correction of all adjustments, tightening of all fasteners and replacement of dirty oil. Timely performance of this service will help make sure you get the best service life and performance from the engine.
Brake fluid replacement
Caution
handle brake fluid with care: the fluid reacts
chemically with paint, plastic, rubber
materials, etc.
Front brake
Place the motorcycle on a level surface and keep the
handlebars straight.
Remove the brake fluid reservoir cap and
diaphragm.
Suck u ...
Malfunction code and defective condition table
* : Immobilizer system equipped model only. ...
Fail-safe function table
Fi system is provided with fail-safe function to allow the engine to start
and the motorcycle to run in a minimum
performance necessary even under malfunction condition.
The engine can start and can run even if the signal in the table is not
received from each sensor. But, the engine
...