Suzuki GSX-R 1000 Service Manual: Ckp sensor removal and installation
Removal
- Remove the clutch cover. Refer to “clutch removal” in section 5c .
- Remove the ckp sensor (1).
Installation
Install the ckp sensor in the reverse order of removal.
Refer to “clutch installation” in section 5c .
Iap sensor inspection
Refer to “dtc “c13” (p0105-h/l): iap sensor circuit malfunction” in section 1a .
Cmp sensor removal and installation
Removal
Remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Remove the pair control solenoid valve. Refer to “pair control solenoid
valve ...
Iap sensor removal and installation
Removal
Lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Disconnect the coupler (1) and vacuum hose (2).
Remove the iap ...
Other materials:
Throttle cable play inspection and adjustment
Inspect throttle cable play
initially at 1 000 km (600 miles, 2 months) and every
6 000 km (4 000 miles, 12 months) thereafter
Inspect and adjust the throttle cable play “a” as follows:
Throttle cable play “a”
2.0 – 4.0 Mm (0.08 – 0.16 In)
Remove the boot (1).
Loosen the lock-nu ...
DTC “c91” (p0500): vehicle speed sensor
circuit malfunction
Detected condition and possible cause
Detected condition
Possible cause
Speedometer does not receive signal from the vehicle
speed sensor for more than 6 sec. When the motorcycle is
running. Ecm does not receive signal from the vehicle
speed sensor for more than ...
Precautions
Keep away from fire or spark.
During disassembling, use care to minimize spillage of
gasoline.
Spilled gasoline should be wiped off immediately.
Work in a well-ventilated area.
For e-33 models, drain fuel from the fuel tank before
...