Suzuki GSX-R 1000 Service Manual: Clutch cable removal and installation
Removal
- Remove the left side cowling. Refer to “exterior parts removal and installation” in section 9d .
- Disconnect the clutch cable from the clutch lever.
Refer to “handlebar removal and installation” in section 6b .
- Remove the clutch cable as shown in the throttle cable routing diagram. Refer to “throttle cable routing diagram” in section 1d .
Installation
- Install the clutch cable as shown in the throttle cable routing diagram. Refer to “throttle cable routing diagram” in section 1d .
- Reinstall the removed parts.
Clutch lever position switch inspection
Inspect the clutch lever position switch in the following
procedures:
disconnect the clutch lever position switch lead
wires (1).
Inspect the clutch lever position switch for co ...
Clutch control system components
Push rod
Clutch release camshaft
Clutch release arm
Clutch cable
1 N·m (0.1 Kgf-m, 0.7
Lbf-ft)
6 N·m
(0.6 Kgf-m, 4.5 Lbf-ft)
10 N·m
(1.0 ...
Other materials:
Balancer shaft journal bearing removal and
installation
Refer to “engine bottom side disassembly” (page 1d-
49).
Refer to “engine bottom side assembly” .
Removal
Remove the balancer shaft journal bearings (1).
Note
do not remove the bearings (1) unless
absolutely necessary.
Make a note of where the bearings are
r ...
Idle speed
Adjust the engine idle speed periodically on the engine at normal operating
temperature.
To adjust the idle speed:
Lift the fuel tank by referring to
the air cleaner section.
Start the engine and warm it
up by running at idling speed
for 10 minutes in summer
(where ambie ...
Lower light bulb
Turn the socket 1 counterclockwise
and remove it.
Turn the socket 2 counterclockwise
and remove it.
Remove the bulb 3 from the
socket.
Caution
Oil from your skin may damage
the headlight bulb or shorten
its life.
Grasp the new bulb with a
c ...