Inspect the clutch lever position switch in the following procedures:
If any abnormality is found, replace the switch with a new one.
Special tool : 09900–25008 (multi circuit tester set)
Tester knob indication continuity ( )
Clutch lever position switch
Clutch cable inspection
Refer to “clutch cable play inspection and adjustment” in section 0b .
Clutch cable play inspection and adjustment
Inspect clutch cable play
every 6 000 km (4 000 miles, 12 months)
Inspect and adjust the clutch cable play “a” as follows.
Clutch cable play “a”
10 – 15 mm (0.4 – 0.6 In)
Lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
  ...
Rear brake master cylinder disassembly and assembly
Refer to “rear brake master cylinder assembly removal and installation” .
Disassembly
Disconnect the reservoir hose (1).
Remove the lock-nut (2).
Remove the brake hose connector (3) and o-ring
(4).
Special tool
: 09900–06108 (snap ring remover
(close
type))
Pu ...
Ect sensor inspection
Refer to “dtc “c15” (p0115-h/l): ect sensor circuit malfunction” in section
1a .
Inspect the ect sensor in the following procedures:
remove the ect sensor. Refer to “ect sensor removal and installation” .
Connect the ect sensor (1) to the circuit tester and
place it in the o ...