Refer to “clutch removal” and “clutch installation” .
Note when inspection and adjusting the clutch lifter pin, it is not necessary to install the clutch onto the countershaft. |
Inspect and adjust the clutch lifter pin in the following procedures:
Tightening torque clutch spring set bolt (a): 10 n·m (1.0 Kgf-m, 7.0 Lbf-ft)
Note tighten the clutch spring set bolt little by little and diagonally. |
Special tool : 09900–20803 (thickness gauge)
Clutch lifter pin height “a” standard: 0.2 – 0.4 Mm (0.008 – 0.016 In)
Note each clutch lifter pin height should be as closely as possible. |
Special tool (a): 09900–20803 (thickness gauge)
Tightening torque clutch lifter pin lock-nut (b): 23 n·m (2.3 Kgf-m, 16.5 Lbf-ft)
Speed sensor removal and installation
Removal
Remove the left side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Disconnect the speed sensor lead wire coupler (1).
Remove the speed sensor (2).
Installation
Install the speed sensor in the reverse order of removal.
Pay atte ...
Battery charging
Initial charging
filling electrolyte
Note
when filling electrolyte, the battery must be
removed from the vehicle and must be put on
the level ground.
Remove the aluminum tape (1) which seals the
battery filler holes “a”.
Remove the caps (2) from the electrolyte ...
Specifications
Service data
Oil pump
Oil
Tightening torque specifications
Reference: for the tightening torque of fastener not specified in this
section, refer to “tightening torque list” in section 0c . ...