Refer to “fuel tank removal and installation” in section 1g .
Note loosen the clutch spring set bolts little by little and diagonally. |
Note if it is difficult to pull out the push rod (12), use a magnetic hand or wire. |
Special tool
(a): 09920–53740 (clutch sleeve hub
holder)
Note if it is difficult to remove the primary driven gear, rotate the crankshaft. |
Tampering with noise control system prohibited
Federal law prohibits the following
acts or the causing there of;
The removal or rendering inoperative
by any person other
than for purposes of maintenance,
repair, or replacement,
of any device or element of
·design incorporated into any
new vehicle for the purpose of
noise ...
Using the testers
Incorrectly connecting the (+) and (.) Probes may
cause the inside of the tester to be burned.
If the voltage and current are not known, make
measurements using the highest range.
When measuring the resistance with the multi-circuit
tester (1), ∞ will be shown as 10.00 ...
Drive chain adjustment
Inspect the drive chain slack
before each use of the motorcycle.
Place the motorcycle on the
side stand. The drive chain
should be adjusted for 20 - 30
mm (0.8 - 1.2 In) of slack, as
shown.
Warning
Too much chain slack can
cause the chain to come off the
sprockets, resul ...