Removal
Installation
Install the cmp sensor in the reverse order of removal.
Pay attention to the following points:
Caution when installing the cmp sensor, make sure to clean the sensor surface. |
Tightening torque cmp sensor bolt (a): 10 n·m (1.0 Kgf-m, 7.0 Lbf-ft)
Ckp sensor inspection
Refer to “ckp sensor inspection” in section 1h .
Steering system inspection
Inspect steering system
initially at 1 000 km (600 miles, 2 months) and every
12 000 km (7 500 miles, 24 months) thereafter
Steering should be adjusted properly for smooth turning
of handlebars and safe running. Overtighten steering
prevents smooth turning of the handlebars and too loose
steer ...
Wiring harness routing diagram
Wiring harness no. 2
Tapping clamp
: insert the clamp from the front side. Place the turn signal
and position light couplers in front of the clamp.
Steel clamp
: clamp the wiring harness at the blue taping point. Bend
the steel clamps to the front side.
...
Crankcase breather (pcv) cover inspection
Inspect the crankcase breather (pcv) cover in the
following procedures:
remove the crankcase breather (pcv) cover. Refer to “crankcase breather
(pcv) hose / reed valve / cover removal and installation” .
Inspect the crankcase breather (pcv) cover for
carbon deposit. If carbon ...