Suzuki GSX-R 1000 Service Manual: Combination meter components
|
Combination meter removal and installation
Removal
Remove the combination meter mounting bolt (1).
Bushing
Disconnect the coupler (2) and remove the
combination meter assembly (3).
Installat ...
Other materials:
Rear wheel assembly removal and installation
Removal
Loosen the axle nut (1).
Raise the rear wheel off the ground and support the
motorcycle with a jack or wooden block.
Caution
make sure that the motorcycle is supported
securely.
Remove the axle nut (1).
Loosen the left and right lock-nuts (2) an ...
DTC “c23” (p1651-h/l): to sensor circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
C23
The sensor voltage should be the
following for 2 sec. And more, after ignition
switch is turned on.
0.2 V ≤ Sensor voltage < 4.8 V
To sensor circuit open or shor ...
Piston ring removal and installation
Removal
Remove the piston. Refer to “engine bottom side disassembly” .
Carefully spread the ring opening with your thumbs
and then push up the opposite side of the 1st ring to
remove it.
Note
do not expand the piston ring excessively
since it is apt to be broken down. ...