Suzuki GSX-R 1000 Service Manual: Combination meter inspection
Led inspection
Check that the leds “a” (fi, fuel, engine rpm, oil pressure/engine coolant, immobilizer (e-02, 19, 24, 51) and meter panel illumination) immediately light up when the ignition switch is turned on.
Check that the other leds “b” (neutral, high-beam and turn signal indicator lights) light up/go off by operating each switch.
If abnormal condition is found, replace the combination meter assembly with a new one after checking its wire harness/coupler. Refer to “combination meter removal and installation” .
Stepping motor inspection and adjustment
- Check that the pointers calibrate immediately after
turning the ignition switch on and stop at zero point.
If abnormal condition is found, replace the combination meter assembly with a new one after checking its wire harness/coupler.
Note
|
- With the adj button (1) pressed, turn the ignition switch on.
- Keep pushing the adj button for more than 3 to 5 sec.
- Release the adj button, then tap it twice.
Pointers will return to the proper position right after the completion of the operation. In the case of the pointers not returning to the proper position after doing above, replace the combination meter unit.
Refer to “combination meter removal and installation” .
Combination meter disassembly and
assembly
Refer to “combination meter removal and installation” .
Disassembly disassemble the combination meter as shown in the combination meter
components. Refer to “combination meter components” .
As ...
Engine coolant temperature indicator light inspection
Inspect the engine coolant temperature meter and indicator light (led) in the
following procedures:
remove the left side cowling. Refer to “exterior parts removal and
installation” in s ...
Other materials:
Sprocket mounting drum dust seal / bearing removal and installation
Removal
Remove the rear wheel assembly. Refer to “rear wheel assembly removal
and installation” in section 2d .
Remove the rear sprocket mounting drum assembly
(1). Refer to “rear sprocket / rear sprocket
mounting drum removal and installation” (page 3a-
3).
Remove the ...
Front brake pad inspection
The extent of brake pads wear can be checked by observing the grooved limit
line “a” on the pads. When the wear exceeds the grooved limit line, replace the
pads with new ones. Refer to “front brake pad replacement” .
Caution
replace the brake pad as a set, otherwise
braking perform ...
Specifications
Service data
Electrical
unit: mm
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Starter motor components”
Reference: for the tightening torque of fastener not specified in this
section, refer to “tightening to ...