Refer to “engine bottom side disassembly” (page 1d- 49).
Refer to “engine bottom side assembly” .
Removal
Remove the conrod crank pin bearings (1).
Note
|
Caution when removing the bearings, be careful not to scratch the conrods and the bearings. |
Installation
When installing the bearings into the conrod cap and conrod, be sure to install the tab “a” first, and then press in the other opposite side of the bearing.
Note inspect and select the conrod crank pin bearing if necessary. Refer to “conrod crank pin bearing inspection and selection” . |
Fuel and oil recommendation
Fuel (for USA and Canada)
Use only unleaded gasoline of at least 90 pump octane
(r/2 + m/2).
Gasoline containing mtbe (meltyl tertiary butyl ether),
less than 10% ethanol, or less than 5% methanol with
appropriate cosolvents and corrosion inhibitor is
permissible.
Fuel (for other countries) ...
Turn signal / side-stand relay inspection
Refer to “electrical components location” in section 0a .
Note
make sure that the battery is fully charged.
Before removing the turn signal/side-stand relay, check
the operation of the turn signal light.
If the turn signal light does not illuminate, inspect the
bulb, turn signa ...
Specifications
Service data
Wheel
unit: mm (in)
Tire
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Front wheel components” “front wheel assembly construction”
“rear wheel components” “rear wheel assembly c ...