Suzuki GSX-R 1000 Service Manual: Cooling circuit inspection
|
|
Inspect the cooling circuit in the following procedures:
- remove the right side cowling. Refer to “exterior parts removal and installation” in section 9d .
- Remove the radiator cap (1) and connect the radiator tester (2) to the filler.
- Pressurize the cooling system with 120 kpa (1.2 Kgf/ cm, 17.6 Psi) of pressure, and then check if it holds the pressure for 10 seconds.
| Caution do not exceed the radiator cap release pressure, or the radiator cap and subsequently the radiator, can be damaged. |
- After finishing the cooling circuit inspection, reinstall the removed parts.
Radiator cap inspection
Inspect the radiator cap in the following procedures:
remove the radiator cap. Refer to “cooling circuit inspection” .
Attach the radiator cap (1) to the radiator tester (2)
as sho ...
Other materials:
Brake fluid
Check the brake fluid level in both front and rear brake fluid reservoirs. If
the level in either reservoir is below the lower mark, inspect for brake pad
wear and leaks.
Warning
Brake fluid is harmful or fatal if
swallowed, and harmful if it
comes in contact with skin or
...
DTC “c42” (p1650): ig switch circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
Ignition switch signal is not input to the ecm.
Ignition system circuit open or short.
Ecm malfunction.
When the id agreement is not verified.
Ecm does not re ...
DTC “c44” (p0130/p0135): ho2 sensor
(ho2s) circuit malfunction
Detected condition and possible cause
Detected condition
Possible cause
C44/P0130
Ho2 sensor output voltage is not input to
ecm during engine operation and running
condition.
Sensor voltage > 1.0 V
Ho2 sensor circuit is open or shorted to the po ...