Suzuki GSX-R 1000 Service Manual: Cooling fan inspection
Cooling fan operating temperature standard (on → off): approx. 100 ?‹C (212 ƒ‹f) (off → on): approx. 105 ?‹C (221 ƒ‹f)
Inspect the cooling fan in the following procedures:
- disconnect the cooling fan motor coupler (1).
- Test the cooling fan motor for load current with an
ammeter connected as shown in the figure.
If the fan motor does not turn, replace the cooling fan assembly with a new one. Refer to “radiator / cooling fan motor removal and installation” .
Note
|
|
- Connect the cooling fan motor coupler.
Radiator reservoir tank removal and
installation
Removal
Remove the right side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Disconnect the reservoir tank inlet hose (1) from the
reservoir tank (2) and ...
Cooling fan relay inspection
Inspect the fan relay in the following procedures:
remove the frame covers. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Remove the cooling fan ...
Other materials:
Speed sensor removal and installation
Removal
Remove the left side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Disconnect the speed sensor lead wire coupler (1).
Remove the speed sensor (2).
Installation
Install the speed sensor in the reverse order of removal.
Pay atte ...
Rear brake caliper removal and installation
Removal
Remove the rear wheel. Refer to “rear wheel assembly removal and
installation” in section 2d .
Drain brake fluid. Refer to “brake fluid replacement” in section 4a .
Remove the brake hose from the caliper by
removing the union bolt (1) and catch the brake fluid
in a ...
Rod guide case tightening torque
Tighten the rod guide case in the following procedures:
measure the effective length l of the torque wrench.
Calculate the reading torque on the torque wrench by
use of the formula shown below.
Special tool
(a): 09940–84710 (rod guide case
wrench)
T: reading torque on the torq ...