Inspect the crankcase breather (pcv) hose in the following procedures:
Refer to “fuel tank removal and installation” in section 1g .
If it is worn or damaged, replace the crankcase breather (pcv) hose with a new one.
Generator removal and installation
Removal
Drain engine oil. Refer to “engine oil and filter replacement” in
section 0b .
Remove the left side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Disconnect the generator coupler (1).
Remove the generator cover (2).
...
DTC “c14” (p0120-h/l): tp sensor circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
C14
Output voltage is not within the following
range.
Difference between actual throttle opening
and opening calculated by ecm is larger
than specified value.
0.2 V ≤ Sensor ...
Engine assembly installation
Install the engine in the reverse order of engine removal.
Pay attention to the following points:
before installing the engine, install the collars (1).
Before installing the engine, install the engine
mounting thrust adjusters (2).
Gradually raise the rear side of ...