Refer to “engine bottom side disassembly” (page 1d- 49).
Refer to “engine bottom side assembly” .
Inspection
Note pull the crankshaft to the left (generator side) so that there is no clearance on the right-side thrust bearing. |
Special tool : 09900–20803 (thickness gauge)
Crankshaft thrust clearance “a” standard: 0.060 – 0.110 Mm (0.0024 – 0.0043 In)
|
Selection
Special tool
(a): 09900–20205 (micrometer (0 – 25
mm))
Right-side thrust bearing thickness standard: 2.420 – 2.440 Mm (0.0953 – 0.0961 In)
Special tool (b): 09900–20803 (thickness gauge)
Note right-side thrust bearing has the same specification as the green (12228-48b00-0e0) of left-side thrust bearing. |
Thrust bearing selection table
|
Radiator cap inspection
Inspect the radiator cap in the following procedures:
remove the radiator cap. Refer to “cooling circuit inspection” .
Attach the radiator cap (1) to the radiator tester (2)
as shown.
Slowly apply pressure to the radiator cap.
If the radiator cap does not hold the pre ...
Battery visual inspection
Inspect the battery in the following procedures:
remove the front seat. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Visually inspect the surface of the battery container.
If any signs of cracking or electrolyte leakage from
the sides of th ...
Rear brake pad replacement
Remove the plug (1) and brake pad mounting pin (2).
Remove the brake pads (3).
Caution
do not operate the brake pedal while the
pads are removed.
Clean up the caliper, especially around the caliper
piston.
Caution
replace the brake pads as a s ...