Toyota RAV4 manuals

Suzuki GSX-R 1000 Service Manual: Cushion lever inspection

Refer to “cushion lever removal and installation” .

Cushion lever

Inspect the cushion levers for damage. If any defects are found, replace the cushion levers with new ones.

Suzuki GSX-R. Cushion lever


Cushion lever removal and installation
Removal Remove the right side cowling and side frame covers. Refer to “exterior parts removal and installation” in section 9d .  Support the motorcycle with a jack to relieve load on t ...

Cushion rod removal and installation
Removal Remove the right side cowling and side frame covers. Refer to “exterior parts removal and installation” in section 9d .  Support the motorcycle with a jack to relieve load on t ...

Other materials:

DTC “c12” (p0335): ckp sensor circuit malfunction.
Detected condition and possible cause Detected condition Possible cause The signal does not reach ecm for 3 sec. Or more, after receiving the starter signal. Metal particles or foreign material being stuck on the ckp sensor and rotor tip.  Ckp ...

Front seat
To remove the front seat. Remove the bolts 1 (right and left).  Raise the front end of the seat and slide it forward. To reinstall the seat, slide the seat hooks into the seat hook retainers on the frame and tighten the bolts securely. Warning Failure to insta ...

Wiring harness routing diagram
Wiring harness no. 2 Tapping clamp : insert the clamp from the front side. Place the turn signal and position light couplers in front of the clamp. Steel clamp : clamp the wiring harness at the blue taping point. Bend the steel clamps to the front side. ...

© 2011-2026 Copyright www.suzukigsxr.org