Removal
Installation
Install the cushion levers in the reverse order of removal.
Pay attention to the following point:
Tightening torque cushion lever mounting nut (a): 98 n·m (9.8 Kgfm, 71.0 Lbf-ft) cushion rod rear mounting nut (b): 98 n·m (9.8 Kgf-m, 71.0 Lbf-ft)
Refer to “exterior parts removal and installation” in section 9d .
Front fork parts inspection
Refer to “front fork disassembly and assembly” .
Inner and outer tubes
Inspect the inner tube and outer tube for scratches
Slide bushing / guide bushing
Inspect the slide bushing and guide bushing for wear or
damage. If they are worn or damaged, replace them with
new ones. If they are not ...
Generator inspection
Generator coil resistance
Remove the left side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Disconnect the generator coupler (1).
Measure the resistance between the three lead
wires.
If the resistance is out of specified value, replace the
...
Side stand
An interlock switch is provided to
cut off the ignition circuit when the
side stand is down and the transmission
is in any gear other than
neutral.
The side stand/ignition interlock
switch works as follows:
if the side stand is down and
the transmission is in gear, the
engine ...