Removal
Installation
Install the cushion rod in the reverse order of removal.
Pay attention to the following points:
|
Tightening torque cushion rod front mounting nut (a): 98 n·m (9.8 Kgf-m, 71.0 Lbf-ft) cushion rod rear mounting nut (b): 98 n·m (9.8 Kgf-m, 71.0 Lbf-ft)
Refer to “exterior parts removal and installation” in section 9d .
Front fork disassembly and assembly
Refer to “front fork removal and installation” (page 2b-
2).
Note
the right and left front forks are installed
symmetrically and therefore the disassembly
procedure for one side is the same as that for
the other side.
Disassembly
Turn the spring pre-load adjuster (1) t ...
Cooling fan inspection
Cooling fan operating temperature
standard
(on → off): approx. 100 ?‹C (212 ƒ‹f)
(off → on): approx. 105 ?‹C (221 ƒ‹f)
Inspect the cooling fan in the following procedures:
disconnect the cooling fan motor coupler (1).
Test the cooling fan motor for load ...
Rear suspension components
Rear shock absorber
Rear shock absorber mounting nut
Cushion rod
Cushion rod mounting nut
Cushion lever
Cushion lever mounting nut
Swingarm pivot lock-nut
Swingarm pivot shaft
Swingarm pivot nut
Swingarm
Chain case
Plate
Chain adjus ...