Disassembly
Assembly
Assembly is in the reverse order of disassembly. Pay attention to the following points:
Note when installing the cmp sensor, clean the sensor surface. |
Tightening torque cmp sensor bolt (a): 10 n·m (1.0 Kgf-m, 7.0 Lbf-ft)
: Thread lock cement
99000–32110
(thread lock cement super “1322” or
equivalent)
Tightening torque pair reed valve cover bolt (b): 10 n·m (1.0 Kgf-m, 7.0 Lbf-ft)
Sds check
Using sds, sample the data at the time of new and periodic vehicle
inspections.
After saving the sampled data in the computer, file them by model and by user.
The periodically filed data help improve the accuracy of troubleshooting since
they can indicate the condition of vehicle
function ...
Throttle valve synchronization
Check and adjust the throttle valve synchronization
among four cylinders.
Start the engine and run it in idling condition
for
warming up.
Stop the warmed-up engine.
Lift and support the fuel tank. Refer to “fuel
tank
removal and installation” in section 1g (page ...
Tightening torque list
Engine
Fi system + intake air system
Cooling system
Chassis
Tightening torque chart
For other bolts and nuts not listed in the preceding page, refer to this
chart:
Conventional bolt
“4” Marked bolt
“7” Marked bolt
...