Refer to “engine top side disassembly” .
Refer to “engine top side assembly” .
Refer to “cylinder head cover disassembly and assembly” .
Cylinder head cover
Clean and check the gasket grooves “a” and pair reed valve mating surfaces “b” of the cylinder head cover.
If there is anything unusual, replace the cylinder head cover with a new one.
Cmp sensor
Note cmp sensor can be checked without removing it from the cylinder head cover. Refer to “dtc “c11” (p0340): cmp sensor circuit malfunction” in section 1a (page 1a- 29). |
Pair reed valve
Inspect the pair reed valves for carbon deposit. If the carbon deposit is found, replace the reed valve with a new one.
General description
Combination meter system description
This combination meter mainly consists of a stepping motor, lcd (liquid
crystal display) and leds (light emitting
diode).
The tachometer pointer is driven by the stepping motor.
The lcds indicate followings:
speed, odo / trip 1 / trip 2 / fuel reserve ...
Immobilizer description (for e-02, 19, 24, 51)
The immobilizer, an anti-theft system, is installed as a
standard equipment.
The immobilizer verifies that the key id agrees with ecm
id by means of radio communication through the
immobilizer antenna. When the id agreement is verified,
the system makes the engine ready to start.
...
Battery visual inspection
Inspect the battery in the following procedures:
remove the front seat. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Visually inspect the surface of the battery container.
If any signs of cracking or electrolyte leakage from
the sides of th ...