Suzuki GSX-R 1000 Service Manual: Cylinder inspection
Refer to “engine top side disassembly” .
Refer to “engine top side assembly” .
Cylinder distortion
Check the gasket surface of the cylinder for distortion.
Use a straightedge and thickness gauge. Take clearance readings at several places. If any reading exceeds the service limit, replace the crankcase set.
Special tool : 09900–20803 (thickness gauge)
Cylinder distortion service limit: 0.02 Mm (0.0008 In)
Cylinder bore
Measure the cylinder bore diameter at six places. If any one of the measurements exceed the limit, overhaul the cylinder and replace the piston with an oversize piston.
The remaining cylinders must also be rebored accordingly; otherwise, the imbalance might cause excessive vibration.
Special tool (a): 09900–20530 (cylinder gauge set)
Cylinder bore standard: 74.500 – 74.515 Mm (2.9331 – 2.9337 In)
Piston-to-cylinder clearance
Refer to “piston and piston ring inspection” (page 1d- 71).
Engine bottom side assembly
Assemble the engine bottom side in the reverse order of
disassembly. Pay attention to the following points:
Note
apply engine oil to each running and sliding
part before reassembling.
...
Piston ring removal and installation
Removal
Remove the piston. Refer to “engine bottom side disassembly” .
Carefully spread the ring opening with your thumbs
and then push up the opposite side of the 1st ring to
remove i ...
Other materials:
Throttle valve synchronization
Check and adjust the throttle valve synchronization
among four cylinders.
Start the engine and run it in idling condition
for
warming up.
Stop the warmed-up engine.
Lift and support the fuel tank. Refer to “fuel
tank
removal and installation” in section 1g (page ...
DTC “c91” (p0500): vehicle speed sensor
circuit malfunction
Detected condition and possible cause
Detected condition
Possible cause
Speedometer does not receive signal from the vehicle
speed sensor for more than 6 sec. When the motorcycle is
running. Ecm does not receive signal from the vehicle
speed sensor for more than ...
Horn inspection
Note
if the horn sound condition is normal, it is not
necessary to inspect the horn button
continuity.
Horn button inspection
Remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Disconnect the left handlebar switch lead ...