The rebound and compression damping force can be individually adjusted by turning the respective adjusters. The rebound damping force adjuster 2 is located at the top of the front fork. The compression damping force adjuster 3 is located at the bottom of the front fork.
To adjust the damping force, set the adjuster to the standard setting first and then adjust the adjuster to the desired position.
To set the rebound and compression damping force, turn the adjuster clockwise until it stops and then turn it counterclockwise.
As you turn the adjuster, you will notice clicks. Count the number of clicks from fully turned-in position.
The standard rebound damping force setting is 9 clicks. The standard compression damping force setting is 14 clicks.
Turn the adjuster clockwise from the standard position to stiffen the damping force. Turn the adjuster counterclockwise to soften the damping force. The damping force should be adjusted gradually, 1/4 turn at a time, to fine-tune the suspension.
Note
: do not loosen the adjuster base 4, or front fork oil will ooze through the adjuster base.
Warning
Adjust the right and left front forks to the same settings. |
License plate light removal and installation
Removal
Remove the frame cover. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Disconnect the license plate light coupler (1).
Remove the nuts.
Remove the license plate light assembly (2).
Installation
Install the license pl ...
Starting the engine
Before attempting to start the
engine, make sure:
The transmission is in neutral.
The engine stop switch is in
the "" position.
Note: this motorcycle has a
starter interlock system for the
ignition and starter circuit. The
engine can only be started if:
  ...
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Rear brake components”
Special tool
...