Inspect the drive chain slack before each use of the motorcycle.
Place the motorcycle on the side stand. The drive chain should be adjusted for 20 - 30 mm (0.8 - 1.2 In) of slack, as shown.
Warning
Inspect and adjust the drive chain slack before each use. |
To adjust the drive chain, follow the procedure below:
Warning
The muffler will be hot enough to burn you for some time after stopping the engine. Wait until the muffler cools to avoid burns. |
Rear axle nut tightening torque: 100 n·m (1 0.0 Kgf-m, 72.5 Lb-ft)
Note
: do not adjust the drive chain beyond the adjustable range 5. Replace the drive chain before drive chain exceeds the limit.
Pair system inspection
Inspect pair system
every 12 000 km (7 500 miles, 24 months)
Inspect the pair (air supply) system periodically. Refer to “pair system
inspection” in section 1b .
Throttle valve synchronization
Inspect throttle valve synchronization
initially at 1 000 km (600 miles, 2 months) (e-33 only)
and ...
Headlight removal and installation
Removal
Remove the body cowling assembly. Refer to “exterior parts removal and
installation” in section 9d .
Remove the air intake pipes (1). Refer to “exterior parts removal and
installation” in section 9d .
Remove the wiring harness no. 2 (2) By
disconnecting the couplers and ...
Gear position (gp) switch removal and installation
Removal
Turn the ignition switch off.
Lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Disconnect the gear position switch lead wire
coupler (1).
Remove the engine sprocket cover. Refer to “engine sprocket r ...