Suzuki GSX-R 1000 Service Manual: Drive mode selector inspection
Inspect the drive mode selector in the following procedures:
- set up the sds tool. (Refer to the sds operation manual for further details.)
- Turn the ignition switch on.
- Click “data monitor”.
- Make sure each of “driving mode selection” on the monitor is indicated “open”.
- Push each of drive mode selector (1) and (2). At this time, if the indication is changed to “gnd”, the function is normal.
Ignition switch removal and installation
Removal
Remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Disconnect the ignition switch lead wire coupler (1).
Disconnect the immo ...
Specifications
Service data
Electrical
unit: mm (in)
Tightening torque specifications
Reference: for the tightening torque of fastener not specified in this
section, refer to “tightening torque list” i ...
Other materials:
Schematic and routing diagram
Engine lubrication system chart diagram
Engine lubrication circuit diagram
...
Front brake caliper parts inspection
Refer to “front brake caliper disassembly and assembly” .
Brake caliper cylinder
Inspect the brake caliper cylinder wall for nicks,
scratches or other damage. If any damage is found,
replace the caliper with a new one.
Brake caliper piston
Inspect the surface of brake caliper pistons for a ...
Battery runs down quickly
Troubleshooting
Step
Action
Yes
No
1
Check accessories which use excessive amounts of
electricity.
Are accessories being installed?
Remove accessories.
Go to step 2.
2
Check the battery for current leakage. Refer to “battery
cu ...