Detected condition and possible cause
Detected condition |
Possible cause |
||
C15 | Output voltage is not with in the following
range.
0.15 V ≤ Sensor voltage < 4.85 V |
|
|
P0115 | H | Sensor voltage is higher than specified value. | |
L | Sensor voltage is lower than specified value. |
Wiring diagram
Troubleshooting
Caution when using the multi-circuit tester, do not strongly touch the terminal of the ecm coupler with a needle pointed tester probe to prevent terminal damage. |
Note after repairing the trouble, clear the dtc using sds tool. Refer to “use of sds diagnosis reset procedures” . |
C15 (use of mode select switch)
Step |
Action |
Yes |
No |
1 |
Special tool Tester knob indication voltage ( ) Ect sensor input voltage 4.5 – 5.5 V ((+) terminal: b/bl – (–) terminal: ground, (+) terminal: b/bl – (–) terminal: b/br) Is the voltage ok? |
Go to step 2. |
|
P0115-h (use of sds)
Step |
Action |
Yes |
No |
1 |
Special tool Tester knob indication continuity test ( ) Ecm couplers (harness side) Is the continuity ok? |
Go to step 2. | B/bl or b/br wire open. |
P0115-l (use of sds)
Step |
Action |
Yes |
No |
|
1 |
Special tool Tester knob indication continuity test ( )
Special tool Tester knob indication voltage ( ) Ect sensor output voltage 0.15 – 4.85 V ((+) terminal: b/bl – (–) terminal: ground) Are the continuity and voltage ok? |
Go to step 2. |
|
|
2 |
Special tool Tester knob indication resistance (Ω) Ect sensor resistance approx. 2.45 KΩ at 20 °c (68 °f) (terminal – terminal)
Is the resistance ok? |
|
Replace the ect
sensor with a new one. Refer to “ect sensor removal and installation” in section 1c . |
Handlebar components
Throttle grip
Grip rubber
Right handlebar switch box
Left handlebar switch box
Right handlebar
Left handlebar
Handlebar expander
Handlebar balancer
Apply handle grip bond.
23
N·m (2.3 Kgf-m, 16.5 Lbf-ft)
5.5 N·m
(0.55 Kgf-m, 4.0 L ...
Water hose inspection
Inspect the water hoses in the following procedures:
remove the side cowlings. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Check the water hoses for crack, damage or engine
coolant leakage. If any defect is found, replace the
water hose wi ...
Starter motor removal and installation
Removal
Turn the ignition switch off and disconnect the
battery (–) lead wire (1).
Lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Disconnect the starter motor lead wire (2).
Remove the starter motor (3).
...