Detected condition and possible cause
Detected condition |
Possible cause |
The operation voltage does not reach the stva. Ecm does not receive communication signal from the stva. Stva can not operate properly or its motor locked |
|
Wiring diagram
Troubleshooting
Caution when using the multi-circuit tester, do not strongly touch the terminal of the ecm coupler with a needle pointed tester probe to prevent terminal damage. |
Note after repairing the trouble, clear the dtc using sds tool. Refer to “use of sds diagnosis reset procedures” . |
Step |
Action |
Yes |
No |
1 |
Is the operation ok? |
Go to step 2. |
|
2 |
Special tool (a): 09900–25008 (multi circuit tester set) Tester knob indication resistance (Ω) Stva continuity ∞Ω¶ (infinity) (terminal . Ground)
Special tool
Stva resistance approx. 6.5 Ω (terminal “a” – terminal “b”, terminal “c” – terminal “d”) |
|
|
Active control inspection
At this time, if an operation sound is heard from the stva, the function is normal.
Wheel / tire / air valve inspection and cleaning
Refer to “tire removal and installation” .
Wheel
Wipe the wheel clean and check for the following points:
distortion and crack
any flaws and scratches at the bead seating area.
Wheel rim runout. Refer to “front wheel related parts inspection”
and “rear wheel rela ...
Clutch cable play inspection and adjustment
Inspect clutch cable play
every 6 000 km (4 000 miles, 12 months)
Inspect and adjust the clutch cable play “a” as follows.
Clutch cable play “a”
10 – 15 mm (0.4 – 0.6 In)
Lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
  ...
License plate light bulb replacement
Caution
when you touch the bulb with your bare
hands, clean the bulb with a cloth moistened
with alcohol or soap water to prevent
premature bulb failure.
Remove the license plate light mounting nuts.
Remove the lens cover (1) by removing the screws.
Re ...