Suzuki GSX-R 1000 Service Manual: Ect sensor inspection

Suzuki GSX-R 1000 Service Manual / Engine / Engine electrical devices / Repair instructions / Ect sensor inspection

Refer to “dtc “c15” (p0115-h/l): ect sensor circuit malfunction” in section 1a .

Inspect the ect sensor in the following procedures:

remove the ect sensor. Refer to “ect sensor removal and installation” .
Connect the ect sensor (1) to the circuit tester and place it in the oil (2) contained in a pan, which is placed on a stove.
Heat the oil to raise its temperature slowly and read the column thermometer (3) and ohmmeter.
If the ect sensor ohmic value does not change in the proportion indicated, replace it with a new one.

Caution

take special care when handling the ect sensor. It may cause damage if it gets an excessive sharp impact.
Do not contact the ect sensor and column thermometer with a pan.

Special tool (a): 09900–25008 (multi circuit
tester set)

Tester knob indication resistance (Ω)

Ect sensor specification

Suzuki GSX-R. Ect sensor inspection

Install the ect sensor. Refer to “ect sensor removal and installation” .

Ect sensor removal and installation

Removal Remove the left side cowling. Refer to “exterior parts removal and installation” in section 9d . Drain engine coolant. Refer to “cooling system inspection” in section 0b . ...

Iat sensor removal and installation

Removal Remove the air cleaner box. Refer to “air cleaner box removal and installation” in section 1d . Remove the iat sensor (1) from the air cleaner box. Installation Install ...

Other materials:

If a collision is imminent, do something
Many riders fear locking up their brakes or haven't learned to swerve to avoid an accident. Many inexperienced riders (and too many seasoned riders) use only their rear brake in an emergency, resulting in unnecessary impacts in some cases and unnecessarily high impact speeds in other case ...

Transmission removal
Remove the engine assembly from the frame. Refer to “engine assembly removal” in section 1d . Remove the engine top side. Refer to “engine top side disassembly” in section 1d . Separate the upper and lower crankcases. Refer to “engine bottom side disassembly” in section 1 ...

Know your limits
Always ride within the boundaries of your own skills. Knowing these limits and staying within them will help you avoid accidents. A major cause of accidents involving only a motorcycle (and no cars) is going too fast through a turn. Before entering a turn, select an appropriately low corne ...