Coolant level
The engine coolant solution should be between "f" (full) and "1..:' (Low) level lines on the engine coolant reservoir. If the level is lower than "1..:' (Low) level line, bring it up to "f" (full) level by adding 50:50 mixture of distilled water and engine coolant.
Warning
Do not drirnk antifreeze or coolant solution. If swallowed, do not induce vomiting. Immediately contact a poison control center or a physician. Avoid inhaling mist or hot vapors; if inhaled, remove to fresh air. If coolant gets in eyes, flush eyes with water and seek medical attention. Wash thoroughly after handling. Solution can be poisonous to animals. Keep out of the reach of children and animals. |
Note
: adding only water will dilute the engine coolant and reduce its effectiveness. Add 50:50 mixture of engine coolant and water.
Rear brake disc removal and installation
Removal
Remove the rear wheel assembly. Refer to “rear wheel assembly removal
and installation” in section 2d .
Remove the rear brake disc.
Installation
Install the rear brake disc in the reverse order of
removal. Pay attention to the following points:
make sure tha ...
Front wheel related parts inspection
Refer to “front wheel assembly removal and installation” .
Tire
Refer to “tire inspection” in section 0b .
Front brake disc
Refer to “front brake disc inspection” in section 4b .
Dust seal
Inspect the lip of dust seals for wear or damage. If any
defects are found, replace the dust seal ...
Rear turn signal light bulb replacement
Caution
when you touch the bulb with your bare
hands, clean the bulb with a cloth moistened
with alcohol or soap water to prevent
premature bulb failure.
Remove the rear turn signal light lens (1).
Replace the bulb (2).
Reinstall the removed parts
...