Inspect the engine coolant temperature meter and indicator light (led) in the following procedures:
If either one or both indications are abnormal, replace the combination meter assembly with a new one. Refer to “combination meter removal and installation” .
Ect sensor removal and installation
Refer to “ect sensor removal and installation” in section 1c .
Front brake pad replacement
Loosen the pad mounting pins (1).
Remove the brake caliper by removing the caliper
mounting bolts (2).
Remove the pad mounting pins (1), brake pads and
spring.
Caution
do not operate the brake lever while the pads
are removed.
Note
when ...
Specifications
Service data
Brake
unit: mm (in)
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Rear brake components”
Reference: for the tightening torque of fastener not specified in this
section, refer to “tightening torqu ...
Side standngnition interlock switch
Check the side stand/ignition
interlock system for proper operation
as follows:
Sit on the motorcycle in the
normal riding position, with the
side stand up.
Shift into first gear, hold the
clutch in, and start the engine.
While continuing to hold the
clutch in ...