Oil quality is a major contributor to your engine's performance and life. Always select good quality engine oil. Suzuki recommends the use of suzuki performance 4 motor oil or equivalent engine oil. Use sf/sg or sh/ sj with jaso ma in api (american petroleum institute) classification.
Api: american petroleum institute jaso: japanese automobile standards organization
Sae engine 011 viscosity
Suzuki recommends the use of sae 1 ow-40 engine oil. If sae 10w-40 engine oil is not available, select an alternative according to the following chart.
Jaso T903
The jaso t903 standard is an index to select engine oils for 4- stroke motorcycle and atv engines. Motorcycle and atv engines lubricate clutch and transmission gears with engine oil. Jaso t903 specifies performance requ irements for motorcycle and atv clutches and transmission.
There are two classes, ma and mb. The oil container has following classification for confirming the standard.
Energy conserving
Suzuki does not recommend the use of "energy conserving" oi ls. Some engine oils which is api sh or greater has "energy conserving" indication in api classification doughnut mark.
These oils can affect engine life and clutch performance.
Front wheel dust seal / bearing removal and installation
Removal
Remove the front wheel assembly. Refer to “front wheel assembly removal
and installation” .
Remove the dust seals using the special tool.
Special tool
(a): 09913–50121 (oil
seal remover)
Remove the wheel bearings using the special tool.
Special tool
(b): 099 ...
DTC “c49” (p1656): pair control solenoid
valve circuit malfunction
Detected condition and possible cause
Detected condition
Possible cause
Pair control solenoid valve voltage is not input to ecm
Pair control solenoid valve circuit open or short.
Pair control solenoid valve malfunction.
Ecm malfunction.
...
Starter relay removal and installation
Removal
Turn the ignition switch off.
Remove the front seat. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Disconnect the battery (–) lead wire (1) from the
battery.
Remove the starter relay cover (2) and disconnect
the starter rel ...