Inspect the engine stop switch in the following procedures:
If any abnormality is found, replace the right handlebar switch assembly with a new one. Refer to “handlebar removal and installation” in section 6b .
Special tool
: 09900–25008 (multi circuit tester
set)
Tester knob indication continuity ( )
Ignition switch inspection
Refer to “ignition switch inspection” in section 9c .
Precautions
Precautions for exhaust system
To avoid
the risk of being burned, do not touch the exhaust system when the
system is hot. Any
service on the exhaust system should be performed when the system is
cool.
Caution
make sure that the exhaust pipes and muffler ...
DTC “c41” (p0230-h/l): fp relay circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
C41
No voltage is applied to fuel pump.
Fuel pump relay circuit open or short.
Fuel pump relay malfunction.
Fuel pump relay switch circuit is shorted to power
source.
...
Cushion rod inspection
Refer to “cushion rod removal and installation” .
Collar and spacer
Remove the collar and spacer from the cushion rod.
Inspect the collar and spacer for any flaws or other
damage. If any defects are found, replace it with a
new one.
Cushion rod bearing
Insert the collar a ...