Refer to “evaporative emission control system removal and installation (only for e-33)” .
Hose
Inspect the hoses for wear or damage. If it is worn or damage, replace the hose with a new one.
Note make sure that the hoses are securely connected. |
Evap canister
Inspect the evap canister for damage to the body. If any defect is found, replace the evap canister with a new one.
Evap system purge control solenoid valve
Note evap system purge control solenoid valve can be checked without removing it from the motorcycle. Refer to “dtc “c62” (p0443): evap system purge control solenoid valve circuit malfunction (e-33 only)” in section 1a . |
Special tool
(a): 09900–25008 (multi circuit
tester set)
Tester knob indication resistance (Ω)
Evap system purge control solenoid valve resistance approx. 32 Ω at 20 °c (68 °f)
Fuel shut-off valve
Gasoline
and gasoline vapor is toxic. A small amount of fuel remains in the fuel shut-off valve when checking it. Do not swallow the fuel when blowing the fuel shut-off valve. |
Rear shock absorber bearing removal and installation
Removal
Remove the rear shock absorber. Refer to “rear shock absorber removal
and installation” .
Remove the spacer (1).
Remove the rear shock absorber bearing with the
special tool.
Special tool
(a): 09943–88211 (pinion bearing
installer)
Installation
C ...
Rear brake light switch inspection and adjustment
Check the rear brake light switch so that the brake light
will come on just before pressure is felt when the brake
pedal is depressed. If the brake light switch adjustment
is necessary, turn the adjuster nut (1) in or out while
holding the brake pedal.
Brake fluid level check
Refer to “bra ...
Radiator reservoir tank removal and
installation
Removal
Remove the right side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Disconnect the reservoir tank inlet hose (1) from the
reservoir tank (2) and drain the engine coolant.
Remove the reservoir tank (2).
Disconnect the reservoir tank ove ...