Suzuki GSX-R 1000 Service Manual: Excva pulley inspection
Inspect the excva pulley in the following procedures:
- remove the excva pulley. Refer to “excv cable removal and installation” .
- Visually inspect the excva pulley for wear and damage. If there is anything unusual, replace the pulley with a new one.
- Install the pulley and excva. Refer to “excva removal and installation” .
Excva removal and installation
Removal
Turn the ignition switch off.
Remove the left side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Connect the special tool (mode select swit ...
Excva adjustment
Inspect the excva operation and adjust it if necessary
in the following steps:
Step 1
Set the excva to the adjustment position. Refer to
“excv cable removal and installation” (page 1k-
6).
...
Other materials:
Lubrication points
Proper lubrication is important for smooth operation and long life of each
working part of the motorcycle.
Major lubrication points are indicated as follows.
Note
before lubricating each part, clean off any rusty spots
and wipe off any grease, oil, dirt or grime.
&nbs ...
Rear brake pedal construction
Footrest bracket no. 2
Footrest bracket no. 1
Rear brake peda
Footrest holder
Footrest
35 N·m (3.5 Kgf-m,
25.5 Lbf-ft)
23 N·m
(2.3 Kgf-m, 16.5 Lbf-ft)
18 N·m
(1.8 Kgf-m, 13.0 Lbf-ft)
Apply grease.
Apply thread lock to the ...
Front wheel components
Front axle
Brake disc bolt
Brake disc
Dust seal
Bearing
Spacer
Air valve
Front wheel
Wheel balancer
Front tire
Collar
Front axle bolt
18 N·m (1.8 Kgf-m,
13.0 Lbf-ft)
100 N·m
(10.0 Kgf-m, 72.5 Lbf-ft)
Apply ...