Suzuki GSX-R 1000 Service Manual: Exhaust control system construction

Suzuki GSX-R 1000 Service Manual / Engine / Exhaust system / Repair instructions / Exhaust control system construction

Suzuki GSX-R. Exhaust control system construction

Excv cable no. 1 (Cl)
Excv cable no. 2 (Op)
When
loosening or tightening the pulley bolt, be sure to fix the pulley with an adjustable wrench, or excva may get damaged.
5 N·m (0.5 Kgf-m, 3.5 Lbf-ft)
42 – 43 Mm (1.65 – 1.69 In)
60 – 61 Mm (2.36 – 2.40 In)
11 – 12 Mm (0.43 – 0.47 In)

Exhaust system components

Exhaust pipe gasket Exhaust pipe assembly Ho2 sensor Connector : install the connector so that the chamfer side faces backward. Muffler chamber Muffler ...

Other materials:

Rear wheel components
Rear axel nut Collar Dust seal Bearing Retainer Rear sprocket Sprocket mounting drum Wheel damper Bearing Spacer Air valve Rear wheel Wheel balancer Rear tire Dust seal Collar Rear brake disc Rear axle 1 ...

Engine stop switch inspection
Inspect the engine stop switch in the following procedures: turn the ignition switch off. Remove the air cleaner box. Refer to “air cleaner box removal and installation” in section 1d . Disconnect the right handlebar switch coupler (1). Inspect the engine stop ...

Rear brake pedal adjustment
The rear brake pedal position must be properly adjusted at all times or the disk brake pads will bear against the disk causing damage to the pads and to the disk surface. Adjust the brake pedal posit~ on in the following manner: Loosen lock nut 1, and turn the push rod 2 to locate t ...