The exhaust emission control system is composed of the pair system, exhaust control system, ho2 sensor, threeway catalyst system and isc system. The fresh air is drawn into the exhaust ports through the pair control solenoid valve and pair reed valves. The pair control solenoid valve is operated by the ecm, which is controlled according to the signals from tps, ects, iaps and ckps. The exhaust gas flow is performed by the exhaust control valve actuator which is controlled by the ecm by changing the exhaust control valve angle. Isc valve adjusts the bypass air volume of the throttle body to control engine idling speed with various sensor signals by varying engine running conditions.
|
Special situations require special care
Of course, there are some times
when full-force braking is not the
correct technique. When the road
surface is wet, loose, or rough,
you should brake with care. When
you're leaned over in a corner,
avoid braking. Straighten up
before braking. Better yet, slow
down before entering the corner. ...
Headlight
To replace the headlight bulbs,
perform the following steps:
Upper light bulb
Remove the bolt 1 to lift the
instrument panel 2.
Turn the cap 3 counterclockwise
and remove it.
Unhook the bulb holder spring
4 and pull out the socket 5.
Pull off the bulb from ...
DTC “c93” (p1769): steering damper
solenoid valve circuit malfunction
Detected condition and possible cause
Detected condition
Possible cause
C93
Steering damper control current does not flow to
the solenoid valve. With ig turned on, ecm
detects a failure of internal circuit element.
Solenoid current does not converge to the ...