Tighten exhaust pipe bolts and muffler bolts initially at 1 000 km (600 miles, 2 months) and every 12 000 km (7 500 miles, 24 months) thereafter
Check the exhaust pipe bolts and muffler bolts to the specified torque.
Tightening torque
exhaust pipe bolt (a): 23 n·m (2.3 Kgf-m, 16.5 Lbf-ft)
muffler chamber connecting bolt (b): 30 n·m (3.0
Kgf-m, 21.5 Lbf-ft)
muffler chamber bracket bolt (c): 25 n·m (2.5 Kgf-m,
18.0 Lbf-ft)
muffler chamber mounting bolt (d): 23 n·m (2.3 Kgfm,
16.5 Lbf-ft)
muffler connecting bolt (e): 23 n·m (2.3 Kgf-m, 16.5
Lbf-ft)
muffler mounting bolt (f): 25 n·m (2.5 Kgf-m, 18.0
Lbf-ft)
Cmp sensor removal and installation
Removal
Remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Remove the pair control solenoid valve. Refer to “pair control solenoid
valve removal and installation” in section 1b .
Disconnect the coupler (1) and remove the cmp
se ...
Specifications
Service data
Electrical
unit: mm (in)
Tightening torque specifications
Reference: for the tightening torque of fastener not specified in this
section, refer to “tightening torque list” in section 0c . ...
Starter torque limiter inspection
Removal
Remove the clutch cover. Refer to “clutch removal” in section 5c .
Remove the washers (1), starter idle gear no. 1 (2)
And no. 2 (3).
Remove the starter idle gear no. 2 Bearing (4), shaft
(5) and washer (6).
Hold the starter clutch with the special tool an ...