Suzuki GSX-R 1000 Service Manual: Exhaust system inspection
Inspect the exhaust pipe, muffler chamber and muffler connection for exhaust gas leakage and mounting condition. If any defect is found, replace the exhaust pipe, muffler chamber or muffler with a new one.
Check the exhaust pipe bolts, muffler connecting bolts and muffler mounting bolts are tightened to their specified torque. Refer to “exhaust system components” .
Muffler / muffler chamber / exhaust pipe
removal and installation
Removal
Loosen the muffler connecting bolts (1).
Remove the mufflers (2) by removing the mounting
bolt and nut (3).
Note
support the muffler to prevent it from falling.
...
Specifications
Service data
Fi sensors
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Exhaust control system construction” “exha ...
Other materials:
Headlight
To replace the headlight bulbs,
perform the following steps:
Upper light bulb
Remove the bolt 1 to lift the
instrument panel 2.
Turn the cap 3 counterclockwise
and remove it.
Unhook the bulb holder spring
4 and pull out the socket 5.
Pull off the bulb from ...
Evaporative emission control system
removal and installation (only for e-33)
Hose
removal
Lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Remove the frame cover assembly. Refer to “exterior parts removal and
installation” in section 9d .
Remove the evap hoses as shown in the evap canister h ...
Excva adjustment
Inspect the excva operation and adjust it if necessary
in the following steps:
Step 1
Set the excva to the adjustment position. Refer to
“excv cable removal and installation” (page 1k-
6).
Step 2
Turn the ignition switch off.
Turn the mode select switch off.
Turn the ...