Side frame cover
Removal
Note the left and right side frame covers are installed symmetrically and therefore the removal/installation procedure for one side is the same as that for the other side. |
|
Installation
Installation is in the reverse order of removal.
Front seat
Removal
Installation
Rear seat / seat tail cover
Removal
Remove the rear seat or seat tail cover with the ignition key.
Rear seat
Seat tail cover
Installation
Slide the hook into the hook retainer and push down firmly until the rear seat/seat tail cover snaps into the locked position.
Windscreen
Removal
Installation
Install the windscreen in the reverse order of removal.
Pay attention to the following point:
Note the screws “a” are 3 mm shorter than the others |
Tightening torque rear view mirror mounting nut (a): 10 n·m (1.0 Kgf-m, 7.0 Lbf-ft)
Body cowling cover
Removal
Installation
Install the body cowling cover in the reverse order of removal.
Side cowling
Removal
|
Installation
Install side cowling in the reverse order of removal.
Pay attention to the following points:
Inner under cowling
Removal
Note the left and right inner under cowlings are installed symmetrically and therefore the removal/installation procedure for one side is the same as that for the other side. |
Installation
Install the inner under cowling in the reverse order of removal.
Body cowling
Removal
Installation
Install the body cowling in the reverse order of removal.
Pay attention to the following point:
Intake pipe
Removal
Installation
Install the intake pipes in the reverse order of removal.
Cowling brace
Removal
Installation
Install the cowling brace in the reverse order of removal.
Pay attention to the following point:
Tightening torque cowling brace mounting bolt (a): 23 n·m (2.3 Kgfm, 16.5 Lbf-ft)
Frame cover
Removal
|
Installation
Install the frame cover assembly in the reverse order of removal.
Front fender
Removal
Refer to “front fork removal and installation” in section 2b .
Installation
Refer to “front fork removal and installation” in section 2b .
Rear fender
Removal
Refer to “rear fender construction” .
Installation
Refer to “rear fender construction” .
Headlight bulb and position light bulb
replacement
Caution
when you touch the bulb with your bare
hands, clean the bulb with a cloth moistened
with alcohol or soap water to prevent
premature bulb failure.
Low beam bulb
Remove the combination meter. Refer to “combination meter removal and
installation” in section 9c .
...
Front brake disc removal and installation
Removal
Remove the front wheel assembly. Refer to “front wheel assembly removal
and installation” in section 2d .
Remove the front brake disc.
Installation
Install the front brake disc in the reverse order of
removal. Pay attention to the following points:
make sure ...
Radiator reservoir tank inspection
Inspect the radiator reservoir tank in the following
procedures:
remove the right side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Inspect the radiator reservoir tank (1) for leaks. If any
defects are found, replace the radiator reservoir tank
...