Suzuki GSX-R 1000 Service Manual: Fail-safe function table
Fi system is provided with fail-safe function to allow the engine to start and the motorcycle to run in a minimum performance necessary even under malfunction condition.
The engine can start and can run even if the signal in the table is not received from each sensor. But, the engine running condition is not complete, providing only emergency help (by fail-safe circuit). In this case, it is necessary to bring the motorcycle to the workshop for complete repair.
When two ignition signals or two injector signals are not received by ecm, the fail-safe circuit can not work and ignition or injection is stopped.
DTC table
In the lcd (display) panel, the malfunction code is indicated from small code
to large code.
*1 To get the proper signal from the throttle position sensor, the sensor basic
position is ...
Fi system troubleshooting
Customer complaint analysis
Record details of the problem (failure, complaint) and how it occurred as
described by the customer. For this purpose,
use of such an inspection form such as following ...
Other materials:
Drive mode selector description
Engine power characteristics can be changed in 3
modes by operating the drive mode selector to meet
various riding conditions and rider’s preference.
Operation
Drive mode is preset at a-mode when the ignition switch
and engine stop switch are turned on. Follow the
procedure below to operat ...
Excva adjustment
Inspect the excva operation and adjust it if necessary
in the following steps:
Step 1
Set the excva to the adjustment position. Refer to
“excv cable removal and installation” (page 1k-
6).
Step 2
Turn the ignition switch off.
Turn the mode select switch off.
Turn the ...
Specifications
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Handlebar components” “steering components” “steering
damper construction”
Reference: for the tightening torque of fastener not specified in this
section ...