Type a
Removal
Installation
Note to prevent the pawl “a” from damage, insert the fastener all the way into the installation hole. |
Type b
Removal
Installation
Note to prevent the pawl (1) from damage, insert the fastener all the way into the installation hole. |
Tp sensor removal and installation
Refer to “throttle body disassembly and assembly” in section 1d .
Removal
Remove the throttle body. Refer to “throttle body
removal and installation” in section 1d (page 1d-
10).
Remove the tp sensor (1) with the special tool.
Special tool
: 09930–11950 (torx wrench (5 mm))
...
Open circuit check
Possible causes for the open circuit are as follows. As
the cause can exist in the connector/coupler or terminal,
they need to be checked carefully.
Loose connection of connector/coupler.
Poor contact of terminal (due to dirt, corrosion or rust,
poor contact tension, entry of f ...
Fuel
Your motorcycle requires premium
unleaded gasoline with a
minimum pump octane rating of
90 ((r+m)/2 method). In some
areas, the only fuels that are
available are oxygenated fuels.
Oxygenated fuels which meet the
minimum octane requirement and
the requirements described below
may be used i ...