
|
Rear fender construction
Rear view mirror constructionExcva adjustment
Inspect the excva operation and adjust it if necessary
in the following steps:
Step 1
Set the excva to the adjustment position. Refer to
“excv cable removal and installation” (page 1k-
6).
Step 2
Turn the ignition switch off.
Turn the mode select switch off.
Turn the ...
Transmission removal
Remove the engine assembly from the frame. Refer to “engine assembly
removal” in section 1d .
Remove the engine top side. Refer to “engine top side disassembly” in
section 1d .
Separate the upper and lower crankcases. Refer to “engine bottom side
disassembly” in section 1 ...
Ecm / various sensors
Since each component is a high-precision part, great
care should be taken not to apply any severe impacts
during removal and installation.
Be careful not to touch the electrical terminals of the
electronic parts (ecm, etc.). The static electricity from
your body may damage them. ...